Commercial Engineer
Full-time Employee
Wyoming
Starts
Immediate
Pay
Will be discussed
Qualifications
Min 4 years experience in installing, provisioning and troubleshooting, repairing telecommunication equipment
• HS Diploma or equivalent
• 3 years of Ethernet and TDM experience
• CCNA certification
• Cisco CIP TI and T2
• Valid state driver’s license applicable to state law.
• Ability to work flexible hours, including evenings, weekends, holidays and overtime and on-call rotation as required.
Other Requirements
Clean driver's license
Job Description
• Assemble and wire components as per Installation Quality Review, including various multiplexers, DDM+, DDM1000, OC3, OC12, OC48, Atrica, Nortel, and DWDM, power equipment, rectifiers and batteries.
• For T1 handoffs loop smart jacks, program and check D-Banks for dial tone. Using Sage Test, break out DSO’s on T1 handoff for dial tone. On T3 handoff, check presence of T3 at DSX3 using T/Berd 310 test set. Check for AC failure battery back-up functions.
• New ring turn-up, check for fiber failure to maintain integrity of mux connectivity. Install and check continuity of hand-off for Ethernet bandwidth. On data installations, complete 9.6 x N continuity, RFC 2544 testing.
• Install equipment, insuring the integrity of power receptacles and grounding.
• Complete turn-up test procedures, 958 all lines, and 700 all DDD lines, loop T1'’, Stress Test T1'’s, check for FAX1 modem connectivity.
• Install Termination Blocks for DSO or T1 hand off (possible RJ48). Test T3 continuity at DSX3. Install T1 Repeaters if loop exceeds 400 feet. Check smart jack for looping and power. Install VDSLs and MRVs as required for Ethernet circuits.
• Install, program, test and turn-up Cisco Routers for access to Internet.
• Installation and testing complex Ethernet circuits, Eline, Vline, 10/100 Meg through 10 Gig.
• For T1 handoffs loop smart jacks, program and check D-Banks for dial tone. Using Sage Test, break out DSO’s on T1 handoff for dial tone. On T3 handoff, check presence of T3 at DSX3 using T/Berd 310 test set. Check for AC failure battery back-up functions.
• New ring turn-up, check for fiber failure to maintain integrity of mux connectivity. Install and check continuity of hand-off for Ethernet bandwidth. On data installations, complete 9.6 x N continuity, RFC 2544 testing.
• Install equipment, insuring the integrity of power receptacles and grounding.
• Complete turn-up test procedures, 958 all lines, and 700 all DDD lines, loop T1'’, Stress Test T1'’s, check for FAX1 modem connectivity.
• Install Termination Blocks for DSO or T1 hand off (possible RJ48). Test T3 continuity at DSX3. Install T1 Repeaters if loop exceeds 400 feet. Check smart jack for looping and power. Install VDSLs and MRVs as required for Ethernet circuits.
• Install, program, test and turn-up Cisco Routers for access to Internet.
• Installation and testing complex Ethernet circuits, Eline, Vline, 10/100 Meg through 10 Gig.
Contact
x x x x Canceled/Expired Listing x x x x
listed •
expires
job listing #32785 •
tiny link cabl.co/eiGX
