Create your free account now! Sign up

Re: standing wave


Try using this formula, this will give you a distance in feet to the standing wave 492 * Vp/ frequency. the Vp is most likley .87% sweep your plant measure the distance between standing waves in MHz. An example would be waves are 4 MHz apart then 492 * .87 / 4 = 107' to the fault, try this and let me know if it halps you.

> Standing waves are impedance mismatches usually caused by damaged cable. A cable gets it's impedance from the ratio between the center conductor and the sheath. 75 ohms is used for cable tv, if the cable is damaged it changes the ratio between the sheath and the center conductor and that will change the ohms from 75 to ....whatever. The best way to find the problem is to sweep it....I know that everyone dosen't have a sweep meter if you have a meter that will scan the entire spectrum that is almost as good as a sweep meter...go back to a point where you have a flat response then find the first place where you have standing waves....The problem is between thoes two points...Also Taps, Actives and just about anything can cause standing waves.......most of the time I have found it to be cable.
>
> > I could really use some pointers in troubleshooting standing wave on an active system (large cascades 450 system, many thanks in advance.
This is CABL.com posting #69277. Tiny Link: cabl.co/msbx
Posted in reply to: Re: standing wave by switchman
There are 3 replies to this message
Re: standing wave Clean Splice 4/26/2002 9:39:00 AM
Re: Standing waves, IMP. Mismatches, CPD, CMI? Clean Splice 4/25/2002 10:02:00 AM
Re: Standing waves, IMP. Mismatches, CPD, CMI? switchman 4/24/2002 5:23:00 PM