In Reply to message #373432 by yanksheels1
Member Member yanksheels1 is not online, or is invisible.
7/8/2017 9:38:20 AM
yanksheels1 Member #: 99986 Registered: 12/19/2014
Posted: 35 View all posts by yanksheels1
Occupation: Fiber Splicer Location: North Carolina
Re: Nano-trenching questions
I would highly suggest the Miller tool for you, it's more user friendly and virtually impossible to mess up. Plus you can see the tube you cutting into the entire time. You're basically cutting off a top section of the buffer, not a deep cut, not scary at all.
This member is a Regular Member.
1 Replies
7/8/2017 6:04:07 PM