In Reply to message #366225 by n4bme
Old School Member Joe50 is not online, or is invisible.
3/19/2015 4:51:28 PM
Joe50 Member #: 3359 Registered: 1996-2001
Posted: 1279 View all posts by Joe50
Company: Catv Expert Occupation: Dir. Location: Montreal, Quebec, Canada
Re: Head End Input location
  1. A power inserter should always be places in the middle of a run of amplifier.

  2. Remove this amp. and try to get the highest signal possible of all your headend gear.

  3. Make sure you do not have an EQ at the input of your amp. Signal should be flat coming out of your headend.

  4. Remove and PAD also This amplifier can easily have an input of 15 dBmV and higher

  5.  Good luck.


Joe 50 This member is a Regular Member.
0 Replies