In Reply to message #365601 by T.L.F.
Journeyman Member jdahl1979 is not online, or is invisible.
2/7/2015 7:39:11 AM
jdahl1979 Member #: 46318 Registered: 5/18/2006
Posted: 100 View all posts by jdahl1979
Company: Time Warner Cable Occupation: Maintenance Tech Location: NC
Re: Copper pinned housing to housing
Are they the ones you can actually loosen and the pin will slide out.  If so, yes I have had trouble.  I ran into them in a system where all the block splices had feed thru connectors too.  It was not much trouble up to 700MHz but it rolled off quick after that.  Some worked fine but I was still able to see a little roll off or just a bad response.  The pin size was a little larger than normal on the ones I worked with.  Seemed like overtightening was the main cause.
This member is a Regular Member.
0 Replies