In Reply to message #353984 by lpraderi
Member Member windwaterwaves is not online, or is invisible.
5/23/2013 7:27:21 PM
windwaterwaves Member #: 86349 Registered: 2/22/2012
Posted: 37 View all posts by windwaterwaves
Company: San Juan cable Occupation: Computer Network Engineer Location: Bellingham Washington
Re: Scientific Atlanta D9477
Where did you find firmware???  I would love that!  Do you have an mqam.config file or any of that stuff?

As I stated in the other reply..

To go into standalone mode, attach to the craft port (serial)

Boot unit, press a key within 2 seconds and it will go into Boot> mode

setbootmode 

0

Reset 

At D9477 MQAM> prompt enter

pidmode 1 0x0 999  

rfoutput 2 off

rfoutput 3 off

rfoutput 4 off
This member is a Regular Member.
0 Replies