"badgerman27;With this device in your hand you have all the drops inactive while you test them. I would expect it is easier and less agravating to the subs to monitor the pin and disconnect/reconnect each drop. Possibly a little more work but much more acceptable to active nodes."
My way is not as customer friendly, but it only takes a few seconds to pull the faceplate and plug it into your tap, and short each drop. The advantage is you get to see the accumulated noise from all of the drops, and see how the noise floor is affected when you short each one individually.
Re: Not Possible Testing At Tap "F" Port
Member #: 52199
Registered: 4/25/2007
Posted:
76
Name:
Rich
Company:
self-employed
Occupation:
sweep tech
Location:
wisconsin
There are 0 replies to this message
